This page will cover how to bring up the ZCU102, ZC702/706, and ZedBoard using the Zynq pre-built release images.

Prerequisites

You should have a SD card with a valid boot partition. Refer this article to set up your SD card.

ZCU102

Make sure SW6 configuration is as shown in the image:

switch configuration for SD boot

For ZCU102, you will need to copy the below files on to your SD card boot partition:

Make sure SW16 configuration is as shown in the image:

switch configuration for SD boot

For ZC702/ZC706, you will need to copy below files on to your SD card boot partition:

Make sure JP 7, 8, 9, 10, and 11 configuration is as shown in the image:

For ZedBoard, you will need to copy below files on to your SD card boot partition: