Zynq UltraScale+ MPSoC VCU TRD 2022.2 - Xilinx Low Latency PL DDR HDMI Video Capture and Display
This page provides all the information related to Design Module 12 - VCU TRD Xilinx low latency (LLP2) PL DDR HDMI Video Capture and Display design.
Table of Contents
1 Overview
This module enables capture of video from an HDMI-Rx subsystem implemented in the PL. The video can be displayed through the HDMI-Tx subsystem implemented in the PL. The module can stream-out and stream-in live captured video frames through an Ethernet interface at ultra-low latencies using Sync IP. This module supports four video streams using AXI broadcaster at capture side and mixer at display side for NV16 and XV20 pixel format. In this design PL_DDR is used for decoding and PS_DDR for encoding so that DDR bandwidth would be enough to support high bandwidth VCU applications requiring simultaneous encoder and decoder operations and transcoding at 4k @60 FPS.
The VCU encoder and decoder operate in slice mode. An input frame is divided into multiple slices (8 or 16) horizontally. The encoder generates a slice_done interrupt at every end of the slice. Generated NAL unit data can be passed to a downstream element immediately without waiting for the frame_done interrupt. The VCU decoder also starts processing data as soon as one slice of data is ready in its circular buffer instead of waiting for complete frame data. The Sync IP does an AXI transaction-level tracking so that the producer and consumer can be synchronized at the granularity of AXI transactions instead of granularity at the video buffer level. Sync IP is responsible for synchronizing buffers between Capture DMA and VCU encoder as both work on same buffer.
The capture element (FB write DMA) writes video buffers in raster-scan order. SyncIP monitors the buffer level while the capture element is writing into DRAM and allows the encoder to read input buffer data if the requested data is already written by DMA, otherwise it blocks the encoder until DMA completes its writes. On the decoder side, the VCU decoder writes decoded video buffer data into DRAM in block-raster scan order and displays reads data in raster-scan order. To avoid display under-run problems, software ensures a phase difference of "~frame_period/2", so that decoder is ahead compare to display.
This design supports the following video interfaces:
Sources:
HDMI-Rx capture pipeline implemented in the PL.
Stream-In from network or internet.
Sinks:
HDMI-Tx display pipeline implemented in the PL.
VCU Codec:
Video Encode/Decode capability using VCU hard block in PL.
AVC/HEVC encoding
Encoder/decoder parameter configuration.
Video formats:
NV16
XV20
Supported Resolutions:
The table below provides the supported resolutions for this design.
Resolution | Command Line | |
Single Stream | Multi-stream | |
4kp60 | √ | NA |
4kp30 | √ | √ (Max 2) |
1080p60 | √ | √ (Max 4 for encoder) (Max 2 for decoder) |
√ - Supported
NA – Not applicable
x – Not supported