...
| Expand | ||
|---|---|---|
| ||
 ‘Test the board’ tab displays board temperature, board call-out picture, device details, boot mode and link to product page. Board temperature is displayed at the top left in degrees centigrade. Navigation options below “Board Temperature” are links to ‘Board Settings’ and ‘Board Interface Test’ tabs The Board call-out picture at the center shows labels of various components of VMK180 Evaluation board. Block below board image is the link to product page. Clicking on “View Product Page” button opens product page in new browser tab. Right most top section of the GUI displays device information such as device name, board part number, rev, serial number, MAC1 and MAC2 addresses. Boot mode section displays the active boot mode and it has option to change the boot mode to a different mode. Click on the dropdown beside “Change” label in boot mode section. It displays various boot modes available. Select the required boot mode and click on “set” button to set the boot mode and reset. A loader is displayed while setting the boot mode. On successful set, a green tick mark is displayed beside “set” button. On failure, a red colored cross icon is displayed. Once the boot mode is set, updated boot mode is displayed besides the “Active” label in boot mode section. Reset button applies power-on-reset. Note: To enable boot modes, the Versal switch positions should be in default boot mode positions [0000]. |
| Expand | ||
|---|---|---|
| ||
 Click on “Board Settings” tab in “Test the board” screen to display the Board settings menu. Board settings (formerly SCUI) helps in monitoring and modifying various parameters like clocks, voltages, power, etc. Click on elements in left to toggle between each menu option. Click on “get” button to obtain corresponding rail information. Users can also click on “get all” button to read all selected rails information. On success, a green tick is displayed under status column. On failure, a red cross is displayed. Hover on status icon to display status message for each status. Few tabs has multiple sub-tabs like get, set and reset values. Click on corresponding sub-tabs to display appropriate sections. Click on get button to fetch values of corresponding items. In set tab, click on set button to set value. Restore will reset the values. For “zSFP Data” and “zQSFP Data” tabs, optional hardware are required to gather valid information. There are 2 SFP28 connectors and 1 QSFP28 connector available on the board. The following optional adapters could be connected to the board:
|
...