This page provides a walkthrough of the Built-In Self Test (BIST) for Zynq-7000 evaluation boards. The BIST may be used to verify board functionality.
...
The following table can be used to determine mode switch configuration. The switches used to set configuration mode depends on board in use. Refer individual board callouts and boot mode tables below to identify appropriate switch.
ZC702
Boot Mode | Setting | SW16 (SW16.1-SW16.5) |
---|---|---|
JTAG | 00000 | OFF, OFF, OFF, OFF, OFF |
Independent JTAG | 10000 | ON, OFF, OFF, OFF, OFF |
QSPI | 00010 | OFF, OFF, OFF, ON, OFF |
SD | 00110 | OFF, OFF, ON, ON, OFF |
PL JTAG Programming Option | Setting | SW10[1:2] |
---|---|---|
None | 00 | OFF, OFF |
USB-to-JTAG | 01 | OFF, ON, |
Cable connector J2 | 10 | ON, OFF |
JTAG Header J58 | 11 | ON, ON, OFF, ON |
ZC706
Boot Mode | Setting | SW11 (SW11.1-SW11.5) |
---|---|---|
JTAG | 00000 | OFF, OFF, OFF, OFF, OFF |
Independent JTAG | 10000 | ON, OFF, OFF, OFF, OFF |
QSPI | 00010 | OFF, OFF, OFF, ON, OFF |
SD | 00110 | OFF, OFF, ON, ON, OFF |
PL JTAG Programming Option | Setting | SW[1:2] |
---|---|---|
None | 00 | OFF, OFF |
USB-to-JTAG (US30) | 01 | OFF, ON, |
Cable Connector J3 | 10 | ON, OFF |
JTAG Header J62 | 11 | ON, ON, OFF, ON |
Board Callouts
More comprehensive component lists available in board user guides.
...
Tests can be entered into the window to run the corresponding test (e.g., typing “1” will run the UART test). A success message will print when a test is passed.
For ZC702 BIST: SWITCH test (5) DIP switches SW15-1 and SW15-2 are tied to SW13 and SW14. SW15-1 and SW15-2 can be set to OFF to use pushbuttons SW13 and SW14 for test, or be kept ON to be used in the test.
Related Links
...
Board Schematics (Links below lead to downloads at the Xilinx website)
Board Product Pages
Master AR list (link)