...
Verify hardware setup—see “General Board HW Setup/Debug” page in related links. Board should be powered off at the start of tutorial.
Set mode switch SW6 to 0010 (QSPI32). See available boot modes below.
Connect to power with provided cables and the board’s 6-pin power supply (J52) and power on board.
Power Check: The three rows of Power Good LEDs should glow green, indicating a good power system.
Note: Descriptions for each power and status LED are available in each board’s user guide provided at the top of this page. Refer to the table below to find the location of the descriptions for each board.
...
Board | LED | Test |
|---|---|---|
ZCU102 ZCU106 | 7 | Clock |
6 | BRAM | |
5 | PL-DDR4 | |
4 | PS-DDR4 | |
3 | Flash | |
2 | I2C | |
1 | DIP | |
0 | PB | |
ZCU104 | 3 (Top left) | Clocking and Memory |
2 (Top right) | EEPROM and I2C | |
1 (Bottom left) | DIP | |
0 (Bottom right) | PB |
...
...
Boot Modes
The following table can be used to determine mode switch configuration. Zynq Ultrascale+ MPSoC devices use switch SW6 for boot configuration. Refer to individual board callouts to locate switch.
...