Table of Contents
Introduction
...
This example test the Multi-Tile Sync feature and shows how to use the MTS APIs.
Changelog
2019.2
Added support for DAC variable output power for GEN 3 devices
- Added support for ADC digital step attenuation for GEN 3 devices
- Added a get enabled interrupts API
- Fixed issue where positive NCO frquencies (fine mixer) were slightly offset
- Fixed issue where calibration 1 mode was changing mixer setting incorrectly (GEN 1/2 devices only)
- Added API for registering RFDC with libmetal
- Added support for reporting DAC current on GEN 3 devices
- Refactor of Clock distribution
- Fixed issue with setting Gain Control Block coefficients on 8x8 devices
- Fixed issue with Setting Time Skew Control Block coefficients
2019.1
- New interpolaton & decimation modes (IP dependent)
- New Image Reject Filter (IP dependent)
- New DAC modes (IP dependent)
- Second Nyquist zone inerse sinc filter (IP dependent)
- Support for alternative DAC bondout (IP dependent)
- New ADC signal detector (IP dependent)
- New calibration override APIs (IP dependent)
- Extended coarse delay (IP dependent)
- New clock distribution network with integer clock division(IP dependent)
- New Common mode over/under interrupts (IP dependent)
- Interrupt APIs now return standard error codes (exempt XRFdc_IntrHandler and XRFdc_SetStatusHandler)
- XRFdc_DynamicPLLConfig now only restarts a tile if it was on previously
...