Zynq UltraScale＋ MPSoC VCU TRD 2019.2 - SDI Video Display
This page is under construction.
Table of Contents
|Table of Contents|
The primary goal of this Design is to demonstrate the capabilities of VCU hard block present in Zynq UltraScale+ EV devices. The TRD will serve as a platform to tune the performance parameters of VCU and arrive at optimal configurations for encoder and decoder blocks with the streaming use case where bandwidth plays a vital role.
This design supports the following video interfaces:
- File source (SD card, USB storage, SATA hard disk).
- Stream-In from network or internet.
- SDI-Tx display pipeline implemented in the PL.
- Video Encode/Decode capability using VCU hard block in PL
- AVC/HEVC encoding.
- Encoder/decoder parameter configuration.
- 1G Ethernet on PS
The table below provides the supported encoder feature in this release.
√ - Supported
NA – Not applicable
x – Not supported
Video encode/Decoder type
File Source/ Stream-In
Playback of the local-file/stream-in with video decoded using VCU and display on SDI-Tx.
The below figure shows the SDI Video Display design hardware block diagram.
The below figure shows the SDI Video Display design software block diagram.
1.1 Board Setup
Refer below link for Board Setup