...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
This page describes the steps for creating and building a 2019.1 PetaLinux project for use with the ZCU111 RFSoC Evaluation tool.
Table of Contents
| Table of Contents | ||
|---|---|---|
|
...
Below are the modification in this TRD for linux-kernel, rfdc drivers, rftool and rfdc example application, on top of 2019.1 petalinux released BSP. For more details on patch information please refer to httphttps://xkb/pages/72www.xilinx.com/support/answers/72405.aspxhtml.
- Kernel patch information as follows:
| Code Block |
|---|
% vim project-spec/meta-user/recipes-kernel/linux/linux-xlnx_%.bbappend
SRC_URI_append = " \
file://0001-power-supply-irps-Add-support-for-irps-supply.patch \
file://0002-drivers-misc-add-support-for-DDR-memory-management.patch \
file://0003-dmaengine-xilinx_dma-In-SG-cyclic-mode-allow-multipl.patch \
file://0004-drivers-misc-add-support-for-selecting-mem-type.patch \
file://0005-i2c-cadence-Implement-timeout.patch \
file://0006-i2c-muxes-update-Mux-register-always.patch \
file://0007-drivers-misc-change-ADC-packet-size-as-per-FIFO-size.patch \
file://0008-drivers-misc-change-parameters-for-of_dma_configure.patch \
file://0009-plmem-clean-up-sysfs-node-and-character-device-nodes.patch \
file://0010-dma-clean-the-BD-s-only-when-done-bit-is-set.patch \
" |
- RFDC driver patch information as follows:
| Code Block |
|---|
% vim project-spec/meta-user/recipes-bsp/rfdc/rfdc_%.bbappend
SRC_URI_append = " \
file://0001-rfdc-add-support-to-turn-off-mixer.patch \
" |
- RFTOOL application patch as follows:
| Code Block |
|---|
% vim project-spec/meta-user/recipes-apps/rftool/rftool.bb |
- RFDC example application patch as follows:
| Code Block |
|---|
% vim project-spec/meta-user/recipes-apps/rfdc-data-write-example/rfdc-data-write-example.bb |
- RFDC Self-test application changes as follows:
| Code Block |
|---|
% vim project-spec/meta-user/recipes-bsp/rfdc-examples/rfdc-selftest_%.bbappend
SRC_URI_append = " \
file://0001-selftest_example-change-default-frequency.patch \
" |
| Note |
|---|
To get "project-spec/meta-user/" folder, please extract files from. bsp using step #3 from section 130973740. |
Once the images are built successfully the user can refer to ZCU111 RFSoC RF Data Converter Evaluation Tool Getting Started Guide for further information on test
...