Versions Compared


  • This line was added.
  • This line was removed.
  • Formatting was changed.


Code Block
$echo  reset_IP_num > /sys/class/reset-mgr/reset    ----> It will reset the IP by providing the  High  to low signal.
$echo reset_IP_num > /sys/class/reset-mgr/reset_assert  ---> it will assert IP by providing the HIGH signal ( the relevant bit is set to High until it receives deassert signal).
$echo reset_IP_num > /sys/class/reset-mgr/reset_deassert  ---> it will deassert IP by providing the LOW signal

Mainline Status

This driver is


in Mainline.

Fixes related to coverity warnings are not yet in mainline (~2 lines)

Change Log


  • reset: reset-zynqmp: Adding support for Xilinx zynqmp reset controller.